Attorney Advertisement:
NJ DWI, Ticket & Criminal Lawyer
Speak with a Lawyer 24/7 at:
1-877-676-7729
Thomas Carroll Blauvelt, LLC
Former NJ Prosecutor
1-877-676-7729
· Old Bridge, New Jersey
499 Marlboro Road
Suite 4
Old Bridge, NJ 08857
· Woodbridge, New Jersey 581 Main Street
6th Floor
Woodbridge, NJ 07095
By Appointment Only
· Bridgewater, New Jersey
991 Route 22 West
Suite 200
Bridgewater, NJ 08807
By Appointment Only
· Piscataway, New Jersey
200 Centennial Avenue
Suite 200
Piscataway, NJ 08854
By Appointment Only
· Morristown, New Jersey
55 Madison Avenue
Suite 400
Morristown, NJ 07960
By Appointment Only
· Jersey City, New Jersey
2500 Plaza 5, 25th Floor
Jersey City, NJ 07311
By Appointment Only
· Fort Lee, New Jersey
1 Bridge Plaza
2nd Floor
Fort Lee, NJ 07024
By Appointment Only
· Hamilton, New Jersey
100 Horizon Center Blvd.
1st/2nd Floor
Hamilton, NJ 08691
By Appointment Only
* Information on how Avvo Ranks Attorneys
** Prior results do not guarantee future case results
Home - NJ Statutes - NJSA 39:3B-10
39:3B-10. School bus seats, seat belts, child restraint systems, regulations
NJSA 39:3B-10
1. In addition to the requirements in Federal Motor Vehicle Safety Standard No. 222 (49 CFR s.571.222) concerning school bus passenger seating and crash protection, each school bus as defined in R.S.39:1-1 shall be equipped with seats of a minimum seat back height of 28 inches, or 24 inches as measured from the seating reference point, and seat belts of the lap belt type for each seating position on the bus or other child restraint systems that are in conformity with applicable federal standards. The design and installation of seat belts or other child restraint systems that are in conformity with applicable federal standards shall conform to the regulations promulgated by the State Board of Education, in consultation with the Director of the Division of Motor Vehicles in the Department of Law and Public Safety. The State board shall promulgate regulations, pursuant to the "Administrative Procedure Act," P.L.1968, c.410 (C.52:14B-1 et seq.), for the design and installation of seat belts or other child restraint systems that are in conformity with applicable federal standards.
As used in this section, "seating reference point" shall be defined as the term is defined in 49 CFR s.571.3.
L.1992,c.92,s.1.
